LXD55 RA Motor Kit
Control Panel , Aluminum spur gear and attaching bolt included in the
kit
The RA motor kits are all Gary has.
The motors are the same for both the RA & DEC.
Back view
This is a DEC motor I got from a person who had one replaced.
You will have to wire up one of the RA motors as shown above.
You will need a cable with the same connector the Autostar uses.
I upload the wiring info soon.
Close up of the DEC motor wiring connector.
LXD55 DEC Motor Wiring
To convert an RA motor to work as a DEC motor you will
need a RJ45 8 connector cable. This is the same type of connector
used
on the Autostar controller ( an Autostar cable will not work for some
reason )
This is also a common computer cat 5 networking cable.
You will have to remove the motor from the plastic housing and
wire the cable as shown below to the motor. Once this is done the RJ45
connector will
plug into the Dec port on the control panel.
With the RJ45 connector positioned as shown above the wiring order of
the
motor ( shown 1 through 8 )
will be the same on the RJ 45 connector ( shown 1 & 8 ).
# 1 Gray wire will go to the #1 position on the RJ45 connector.
#2 orange wire will go the the 2nd pin from the left on the RJ45 connector.
So on & so on.
The #8 Brown wire will go to the #8 pin on the RJ45 connector ( far
right )